Preparing LWA2 & LWA3These hard points were made in Section 2. All I needed to do in this step was to position them correctly, flox them in place, & let cure. After I cut up the UNI & BID glass strips per plan, I added additional flox around the hard points, and lay-up the glass per direction. Peel plies were applied as well. They turned out pretty well...
Picture of one of the 2 LAW2's... |
Here's a picture of one of the 2 LAW3's... I have to sand off the little bit of overhang glass at the edge later on. |